Ultimaker: Difference between revisions

Ultimaker (view source)

112 bytes removed , 1 July 2020

Retired Printer

144

edits

@@ Line 12: / Line 12: @@
 !Status
-|Operational
+| Broken - Retired
-|Nearly-Operational
+| Broken - Retired
 |-
 !Material
-|3mm PLA only
+|ABS only
 |3mm PLA only
 |-
 !Performance State
-|Hardware: works well</br>
+|Hardware: works well
-Software: prontserve causes buggy printing.
+Software: OctoPrint works well
-|Hardware: 90% complete</br>
+|Hardware: works well
-Software: prontserve requires setup.
+Software: OctoPrint works well
 |-
 !Pending tasks
-|Fix prontserve on the raspberry pi
+|
-|Install prontserve on ultimaker2 host machine
+|
 |-
@@ Line 44: / Line 44: @@
 Rob found a Toronto wholesaler [http://www.dynamishobbies.com/ DynamisHobbies.com] who left a sample spool of 1.75mm at the lab.
-All PLA is hygroscopic (water absorbing) and exposure to moisture over time degrades the material. We have a (mostly) airtight latching storage bin with desiccant (CaCl[sub]2[/sub]) to reduce moisture internally. Store PLA inside this bin, keep it closed and open it only when needed.
+All PLA is hygroscopic (water absorbing) and exposure to moisture over time degrades the material. We have a (mostly) airtight latching storage bin with desiccant (CaCl{{sub|2}}) to reduce moisture internally. Store PLA inside this bin, keep it closed and open it only when needed.
 NB: ABS and other mystery inventory is stored in this bin as well!