111
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes
No edit summary |
|||
| Line 18: | Line 18: | ||
==Known Issues and Fixes== | ==Known Issues and Fixes== | ||
* ****IMPORTANT**** Octopi will disconnect from Ultimaker 2 if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2 | |||
*The white zip tie holding the extruder together can block the tensioner (the black piece) from contacting the filament. Make sure the tensioner clears the zip tie | *The white zip tie holding the extruder together can block the tensioner (the black piece) from contacting the filament. Make sure the tensioner clears the zip tie | ||
*Bed is warped (higher up in the middle, lower down on the sides). Levelling the bed is unlikely to fix this. Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). Turn the threaded rod counter-clockwise to lower, clockwise to raise. | *Bed is warped (higher up in the middle, lower down on the sides). Levelling the bed is unlikely to fix this. Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). Turn the threaded rod counter-clockwise to lower, clockwise to raise. | ||