111
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
|||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
*Last known good settings: (06-Jun-2017) 40 mm/s, 220 deg, 110% flow, nozzle size 0.3mm | |||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
**Make sure the black peice of the extruder is behind the white zip tie and is contacting the filament!!! Shove that red wedge in good so it doesn't slip out of place | |||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ||
| Line 12: | Line 14: | ||
** If head too close & extruder starts clicking, that can cause filament feed problems. | ** If head too close & extruder starts clicking, that can cause filament feed problems. | ||
* Loaded with Pastel Pink 2.85mm PLA | * Loaded with Pastel Pink 2.85mm PLA | ||
* '''PLA ONLY!''' (to prevent nozzle contamination) | * '''PLA ONLY!''' (to prevent nozzle contamination) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||