Ultimaker 2: Difference between revisions

Jump to navigation Jump to search
(→‎Known Issues and Fixes: remove "old nozzle" & "extruder zip-tie" note after work done.)
(→‎Status: edit to remove line for old extruder)
Line 8: Line 8:
*'''Last known good settings''': (06-Jun-2017) 40 mm/s, 220 deg, 110% flow, nozzle size 0.3mm
*'''Last known good settings''': (06-Jun-2017) 40 mm/s, 220 deg, 110% flow, nozzle size 0.3mm
* Operational ... it can be '''Problematic'''
* Operational ... it can be '''Problematic'''
**Make sure the black peice of the extruder is behind the white zip tie and is contacting the filament!!! Shove that red wedge in good so it doesn't slip out of place
** Using a Brim to hold parts to the Print Bed is strongly recommended.
** Using a Brim to hold parts to the Print Bed is strongly recommended.
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.)
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.)
Retrieved from "https://knowledge.hacklab.to/wiki/Ultimaker_2"