Ultimaker Operation Manual: Difference between revisions
Jump to navigation
Jump to search
→Checklist: Changed wait time
m (→Checklist: Clarified stop instructions) |
(→Checklist: Changed wait time) |
||
| Line 20: | Line 20: | ||
# Heat up extruder with "settemp 220" | # Heat up extruder with "settemp 220" | ||
# '''Watch heat''' using "gettemp" | # '''Watch heat''' using "gettemp" | ||
# Wait about | # Wait about '''1.0 - 1.5 minutes''' once at temperature | ||
# Extrude 1mm at a time until ooze seems connected to your command "extrude 1" | # Extrude 1mm at a time until ooze seems connected to your command "extrude 1" | ||
#* Be careful. If after 5mm the plastic doesn't seem to be flowing, stop and cool it down. The Bowden cable may have come loose again or something else might be happening. | #* Be careful. If after 5mm the plastic doesn't seem to be flowing, stop and cool it down. The Bowden cable may have come loose again or something else might be happening. | ||