Ultimaker Operation Manual: Difference between revisions

Ultimaker Operation Manual (view source)

104 bytes removed , 27 September 2015

update Overview

94

edits

@@ Line 1: / Line 1: @@
-This page holds instructions for transfering G-Code and doing the print jobs on the Ultimaker. For generating the G-Code see [[Ultimaker Slicing Page]].
+This page holds instructions for transferring G-Code and doing the print jobs on the Ultimakers. For generating the G-Code see [[Ultimaker Slicing Page]].
 == Overview ==
-Currently, the working Ultimaker is hooked up to a RaspberryPi sitting on the small workbench behind the bar.
+Currently, the working Ultimakers are hooked up to RaspberryPis sitting on the 3D Printer rack in The Hub, next to the Shop door.
-Until Rob fixes his cloudslicer project (which is already totally sweet but only runs Slic3r for the moment), the procedure is to generate G-Code on your computer or the hacklab public computer with Cura and then upload the G-Code to the RaspberryPi and run pronsole via SSH to serve it to the Ultimaker.
+The procedure is to generate G-Code on your computer or the Hacklab public computer with Cura and then upload the G-Code to the RaspberryPi using the OctoPrint web GUI interface.
 == Checklist ==