3D Printers/Ender 5 plus: Difference between revisions

From Hacklab.TO Public Wiki
Jump to navigation Jump to search
Line 42: Line 42:
== Calibration notes ==
== Calibration notes ==


* using the built in e-steps I got 137.85 steps/mm
* using the built in e-steps I got 137.85 steps/mm (this is in the firmware, in the slicer you just change the flow rate)


== Printable Upgrades ==
== Printable Upgrades ==

Revision as of 15:47, 5 December 2022

FlashForge Creator Pro

Status


Last Known Good Settings

Date Filament type, colour, brand First layer Other layers Notes
June 28, 2020 asdfsadfsdaf asfsadfsadf

Hardware

  • Probe is official BL-Touch (which is stock on the E5P)
    • it should be set and forget, don't think it needs to be recalibrated ever unless some hardware thing changes
    • can use 'babystep' feature to live z-adjust during printing
    • refer to this for setting the probe offset https://www.youtube.com/watch?v=y_1Kg45APko

Software

To use pronterface to control the printer, first power up the printer, then connect the usb cable to your computer. On win10 it should auto-detect and possibly install 'maple' (wtf that is lol). Baud 115200


Calibration notes

  • using the built in e-steps I got 137.85 steps/mm (this is in the firmware, in the slicer you just change the flow rate)

Printable Upgrades

https://www.thingiverse.com/thing:4742487 https://www.thingiverse.com/thing:4742501

Voron cooling fans: https://www.thingiverse.com/thing:5171295

Z-axis sync indicators: https://www.thingiverse.com/thing:4460521

Glass Print Plate Usage

Usage

SD Card

Slicer Settings

* Using Cura, seems to be what most people are using
    • flow settings are "hard-baked" into extrusion values in the gcode. So if you set flow to 95% in cura, there will NOT be an M221 S95 command in the gcode and so the printer will say on its screen that flow is 100%, but really the flow has been reduced.

A few random printing tips

know what you're doing!!! this printer is for seasoned vets only!!

Octoprint at octopi4.hacklab.to

I wish...

Maintenance Resources

put stuff here lol

Maintenance Log

Most recent entries at the top.

Date Notes Entry By
June 9, 2022 Setting up the printer Rana