111
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 08:20, 12 January 2019
, 12 January 2019→Glass Print Plate Usage
| Line 55: | Line 55: | ||
== Glass Print Plate Usage == | == Glass Print Plate Usage == | ||
Glass plate is of GO-3D brand, | Glass plate is of GO-3D brand, hopefully real mccoy stuff that is flat... It is covered with a PEI sheet that is adhered to the plate with 3M 468MP High Temp Tape. A blue silicone heat transfer sheet keeps the glass in place with friction and fills gaps between the plate and the aluminum bed, it is a type of silicone used for heat sinks for electronics. | ||
* NEVER CLAMP glass plate to bed. It will cause warping of the glass plate. Yes glass warps and bends, look it up. The silicone will keep it in place no problem. | * NEVER CLAMP glass plate to bed. It will cause warping of the glass plate. Yes glass warps and bends, look it up. The silicone sheet will keep it in place no problem. | ||
*One corner of the print plate is marked 'Front Right' and is blacked in | *One corner of the print plate is marked 'Front Right' and is blacked in a little around the corner. When facing the printer, this corner goes to corner that is on the right-hand side and is closest to you (duh, but just to be sure...). | ||
*The temperature of the surface of the glass plate will be lower than the aluminum bed, may have to use higher bed temp than on other printers | *The temperature of the surface of the glass plate will be lower than the aluminum bed, may have to use higher bed temp than on other printers | ||
* PEI sheet is prep-free surface for ABS and PLA, hot or cold. If you have another material, check first to make sure it will work on PEI. If not, then put tape on top of the sheet and then glue/hairspray/whatever. | * PEI sheet is prep-free surface for ABS and PLA, hot or cold. If you have another material, check first to make sure it will work on PEI. If not, then put tape on top of the sheet and then glue/hairspray/whatever. | ||
* Clean PEI sheet with 85% Isopropyl Alcohol and a paper towel, a green spray bottle should be near the printer. Can also use soap and water. | * Clean PEI sheet with 85% Isopropyl Alcohol and a paper towel, a green spray bottle should be near the printer. Can also use soap and water. | ||
* The flat spatula used to remove objects from the print plate is also useful for removing glass plate from silicone sheet. | * The flat spatula used to remove objects from the print plate is also useful for removing glass plate from silicone sheet. | ||
== Usage == | == Usage == | ||