3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 18:07, 28 January 2020
, 28 January 2020→Status
(→Status) |
|||
| Line 18: | Line 18: | ||
!Notes | !Notes | ||
|- | |- | ||
| Jan 2020 | |||
| Blue PETG | |||
| Default Slic3r bundle settings | |||
| | |||
| Last known good workflow (for Chalmers) | |||
| 1. Install slicer config | |||
| 2. Install slicer config bundle | |||
| 3. set slicer to simple mode | |||
| 4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | |||
| 5. slice model | |||
| 6. load sliced model into GpxUi | |||
| 7. translate to Replicator 2 RepRap | |||
|- | |||
| Nov, 2018 | | Nov, 2018 | ||
| Hatchbox forest green ABS | | Hatchbox forest green ABS | ||