3D Printers/FlashForge Creator Pro: Difference between revisions

Jump to navigation Jump to search

3D Printers/FlashForge Creator Pro (view source)

Revision as of 18:12, 28 January 2020

164 bytes removed ,  28 January 2020
→‎Usage
Line 93: Line 93:
However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended.
However, it is possible, to use the printer with open source toolchain based on Slic3r. [https://github.com/prusa3d/Slic3r/releases Slic3r Prusa Edition] is highly recommended.


Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html
Use Instructions in the log from Jan 2020 at the top of this wiki.
This link is dead, are there instructions anywhere else? --[[User:Hiker|Hiker]] ([[User talk:Hiker|talk]]) 19:14, 22 April 2018 (EDT)


It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint.
It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint.
Retrieved from "https://knowledge.hacklab.to/wiki/Special:MobileDiff/1842"

Navigation menu