3D Printers/FlashForge Creator Pro: Difference between revisions

From Hacklab.TO Public Wiki
Jump to navigation Jump to search
Line 14: Line 14:
* Load config -- http://data.flamy.ca/printer_config/config.ini
* Load config -- http://data.flamy.ca/printer_config/config.ini
* Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
* Load config bundle -- http://data.flamy.ca/printer_config/slic3r_config_bundle.ini
* Select File -> Quck Slice and Save As.. or click on 'Send To Printer' (the l
* Select File -> Quck Slice and Save As.. or click on 'Send To Printer'


It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print

Revision as of 23:30, 29 December 2016

!

FlashForge Creator Pro

Status

Operational

Usage

Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r

Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html

Slic3r Settings

It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print

Octoprint at octopi4.hacklab.to

Camera Stream

Open with VLC File -> Open Network Stream rtsp://admin:@192.168.111.44:554/user=admin&password=&channel=1&stream=0.sdp