111
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 20:03, 9 August 2018
, 9 August 2018→Lokbuild Print Surface
| Line 62: | Line 62: | ||
*DO NOT put acetone on surface or high % isopropyl, this is will damage the surface. | *DO NOT put acetone on surface or high % isopropyl, this is will damage the surface. | ||
----- | ----- | ||
Print not sticking? Raise the bed up a little to squish that first layer more. | |||
----- | |||
If your material is not compatible with lokbuild, put tape on top of it, then put hairspray or glue stick or whatever. | If your material is not compatible with lokbuild, put tape on top of it, then put hairspray or glue stick or whatever. | ||