3D Printers/FlashForge Creator Pro: Difference between revisions

From Hacklab.TO Public Wiki
Jump to navigation Jump to search
(→‎Maintenance Log: fixed right drive motor)
(Add features, update status and log)
Line 2: Line 2:


== Status ==
== Status ==
Operational
<onlyinclude>
* Operational
* Needs vertical head alignment
* [[FlashForge Creator Pro#Usage|Slic3r Settings here]]
* '''http://octopi4.hacklab.to/'''</onlyinclude>
 
== Features ==
* FlashForge Creator Pro
* 225 x 145 x 150 mm print volume (less with dual extrusion?)
* Dual extruder
* 1.75mm filament
* Absolute max temp: 250 C
* Heated bed


== Usage ==
== Usage ==

Revision as of 22:09, 1 February 2017

FlashForge Creator Pro

Status

Features

  • FlashForge Creator Pro
  • 225 x 145 x 150 mm print volume (less with dual extrusion?)
  • Dual extruder
  • 1.75mm filament
  • Absolute max temp: 250 C
  • Heated bed

Usage

Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r

Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html

Slic3r Settings

It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print

Octoprint at octopi4.hacklab.to

Maintenance Resources

Cleaning the Extruder Drive Gear on a FlashForge Creator Pro 3D Printer -- https://www.youtube.com/watch?v=vmIY9_6s8Ss

Flashforge Creator Pro ABS Nozzle Cleaning -- https://www.youtube.com/watch?v=x3yp6H4D_ao


Maintenance Log

Most recent entries at the top.

Date Notes Entry By
Jan 31, 2017 Corrected wire order on right drive motor, both motors feed filament correctly now. Nozzles need to be vertically aligned, one is lower than the other and scrapes the previous layers. Adam
Jan 26, 2017 Replaced Fillament with Orange Monoprice. Cleaned nozzles, drive gears. Right gear doesn't pull fillament properly. Either gear or nozzle needs to be replaced. Alex V, Myles, Mike P
Dec 29, 2016 Bed level adjusted. Heated bed support needs to be disassembled and left front (my left) leveling assembly needs to be readjusted Alex V.
Nov 29, 2016 Right Extruder cleaned, Left Extruder should be clean too Rana