3D Printers/FlashForge Creator Pro

From Hacklab.TO Public Wiki
Revision as of 00:15, 23 August 2016 by Alex (talk | contribs) (→‎Usage)
Jump to navigation Jump to search

!

FlashForge Creator Pro

Status

Operational

Usage

Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r

Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html

Slic3r Settings

It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print

Octoprint at octopi4.hacklab.to

Camera Stream

Open with VLC File -> Open Network Stream rtsp://admin:@192.168.111.44:554/user=admin&password=&channel=1&stream=0.sdp