3D Printers/FlashForge Creator Pro

From Hacklab.TO Public Wiki
Revision as of 00:13, 30 December 2016 by Alex (talk | contribs) (Camera stream no longer available)
Jump to navigation Jump to search
FlashForge Creator Pro

Status

Operational

Usage

Creator Pro uses different toolchain than the rest of the printers in the lab, because Makerbot. Fortunately it is still possible to use open-source toolchain based on Slic3r

Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html

Slic3r Settings

It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print

Octoprint at octopi4.hacklab.to


Maintenance Log

Most recent entries at the top.

Date Notes Entry By
Dec 29, 2016 Bed level adjusted. Heated bed support needs to be disassembled and left front (my left) leveling assembly needs to be readjusted Alex V.
Nov 29, 2016 Right Extruder cleaned, Left Extruder should be clean too Rana