Ultimaker 1: Difference between revisions

Jump to navigation Jump to search
110 bytes removed ,  17 May 2017
Undo revision 1247 by Igor (talk) oops, wrong ultimaker
(→‎Status: Not working, needs new X homing switch)
(Undo revision 1247 by Igor (talk) oops, wrong ultimaker)
Line 5: Line 5:
==Status==
==Status==
<onlyinclude>
<onlyinclude>
* '''Not working, X homing switch broken!''' Igor will bring replacement part
* Operational
* WHITE: 2.85mm PLA (use 210&deg;-220&deg;)
* WHITE: 2.85mm PLA (use 210&deg;-220&deg;)
* BLACK: 2.85mm PLA/PHA Filament (use 220&deg;-230&deg;) -- this is a bit more flexible than plain PLA
* BLACK: 2.85mm PLA/PHA Filament (use 220&deg;-230&deg;) -- this is a bit more flexible than plain PLA
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2)
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2)
* '''Heated bed currently not working''' the relay is toast, will attempt to switch to the second relay on the board.
* '''Heated bed currently not working''' (mid-way through fixing that).
* [[3D_Printers#Cura_15|Cura 15 Settings here]]
* [[3D_Printers#Cura_15|Cura 15 Settings here]]
* '''http://octopi.hacklab.to/'''</onlyinclude>
* '''http://octopi.hacklab.to/'''</onlyinclude>

Navigation menu