Type A: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 17: | Line 17: | ||
|January 1 2016 | |January 1 2016 | ||
|Print head not extruding. Mechanics and octopi commands seem to be working fine, but filament does not extrude from print head. | |Print head not extruding. Mechanics and octopi commands seem to be working fine, but filament does not extrude from print head. Also, the Z axis is off a little, and home is slightly too close to the print head. Easily adjusted by hand. | ||
|emmy | |emmy | ||
Revision as of 01:10, 2 January 2016
This page documents Type A
Status
- This Ultimaker is currently functional and in reasonable to good condition!
- Uses 1.75mm PLA filament.
- It is managed and accessible from the web GUI: http://octopi.hacklab.to/
Machine Log
| Date | Notes | Entry By |
|---|---|---|
| January 1 2016 | Print head not extruding. Mechanics and octopi commands seem to be working fine, but filament does not extrude from print head. Also, the Z axis is off a little, and home is slightly too close to the print head. Easily adjusted by hand. | emmy |