This page documents Ultimaker #1 (Guy)
- This Ultimaker is currently functional and in reasonable to good condition!
|April 24, 2013||Squeaking noise observed from Y axis axle.
Endcap inset screw noticed to be loose, requires new endcap to be printed, and screw not to be overtightened.
|April 12, 2013||Bed leveling assist tool printed and built.||Norm|
|April 8, 2013||Belts retensioned, new bearing endcaps installed to reduce backlash further.||Norm|
|April 6, 2013||Z axis calibration fixed, Z steps/mm in new profile on Git.
X/Y axis backlash observed, infill not meeting walls, delamination observed.
|March 31, 2013||Z axis calibration issues observed.
25mm Test cube showed ~6.8% Z axis error.