Ultimaker 2: Difference between revisions

From Hacklab.TO Public Wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 14: Line 14:
|-
|-


|Apr 27, 2013
|April 29, 2013
|Printed fourth X/Y bushing block and Raspberry Pi bracket
|Norm
|-
 
|April 27, 2013
|Assembled 3/4 X/Y bushing blocks, 4th print failed mid-print.
|Assembled 3/4 X/Y bushing blocks, 4th print failed mid-print.
|Norm
|Norm
|-
|-


|Apr 24, 2013
|April 24, 2013
|Unmounted dual extruder.
|Unmounted dual extruder.
Stripped out X/Y gantry parts for rebuild (X/Y blocks broken). <br/>
Stripped out X/Y gantry parts for rebuild (X/Y blocks broken). <br/>
Line 27: Line 32:
|-
|-


|Apr 22, 2013
|April 22, 2013
|Reorganized shelf to accommodate the Ultimaker, organized materials and supplies.  
|Reorganized shelf to accommodate the Ultimaker, organized materials and supplies.  
|Norm
|Norm

Revision as of 11:53, 30 April 2013

This page documents Ultimaker #2 (Fawkes) [A phoenix from the ashes]

Status

  • The ultimaker has been non-functional since 'day 1'. It was a donation to the lab in a semi-built, non functional state.
  • Rebuild currently lead by aonomus/Norm

Machine Log

Date Notes Entry By
April 29, 2013 Printed fourth X/Y bushing block and Raspberry Pi bracket Norm
April 27, 2013 Assembled 3/4 X/Y bushing blocks, 4th print failed mid-print. Norm
April 24, 2013 Unmounted dual extruder.

Stripped out X/Y gantry parts for rebuild (X/Y blocks broken).
Observed Z acme rod bent.
Remounted Arduino Mega and driver board.

Norm
April 22, 2013 Reorganized shelf to accommodate the Ultimaker, organized materials and supplies. Norm

To Do List

  • Repairs
    • Finish to-do list/upgrade list
    • Reprint X/Y bushing blocks, remount
    • Print tensioners, install
    • Print new extruder in entirety, mount
    • Print Raspberry Pi mounting plate, mount pi, wire up
    • Straighten Z axis acme rod
    • Crimp cable going to print head
    • Remount X/Y gantry system
    • Order hot end
    • Order boden cable
    • Order extruder (dependent on success of printable extruder)
    • Flash firmware
    • Calibrate endstops
  • Printable Upgrades
    • Spool holder
    • Magnetically attached print bed
    • Motor mounts
    • Fan cowling
    • Z axis home switch adjuster
    • Axis end-caps