111
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
(→Status) |
||
| Line 9: | Line 9: | ||
*'''Last known good settings''': (05-Dec-2017, Pastel Yellow PLA) '''220°''', 138% flow, print @ '''50mm/s''' (1/2 speed), travel @ '''150mm/s''', 0.4 mm nozzle size, 2.85mm filament size. | *'''Last known good settings''': (05-Dec-2017, Pastel Yellow PLA) '''220°''', 138% flow, print @ '''50mm/s''' (1/2 speed), travel @ '''150mm/s''', 0.4 mm nozzle size, 2.85mm filament size. | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
** Changing filaments has become a pain in the neck, see Known Issues section for details. Full printhead overhaul is probably due, but meh could get a couple more print-hours out of it lol | |||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ||