Craftex CT089 Lathe

From Hacklab.TO Public Wiki
(Redirected from HL0037)
Jump to navigation Jump to search

This is Hacklab's main lathe. It was purchased by lab members from Busy Bee tools in 2016

Quick specs

  • 320mm/12.6" swing over bed / 210mm/8.26" swing over cross slide
  • 600mm/23.6" maximum work piece length
  • 1HP spindle
  • 6 speed gearbox * 2 belt positions - 60-1600 RPM
  • Thread pitch changed by swapping gears :(
  • Slow power feed on Z and X geared down from threading feed, there is no safety clutch, so don't run it into the ends!
  • Z travel: 21.6"
  • X travel: 7"
  • Compound travel: 4"
  • 4-sided tool post takes bits up to 15.5mm tall to center line, up to 21.8mm overall
  • MT6 spindle with 3x M10 bolt pattern for mounting chucks
  • MT3 tail stock

File:Ct089.jpg

Usage & Safety

The metal lathe is both a precision machine and also powerful enough to seriously hurt you. It needs to be treated with the same respect you would give any precision tool. All members are welcome to use the machine after being shown how to use it properly.

  1. Only trained members may use this machine.
  2. Tie back long hair, remove long sleeved shirts and jewelry.
  3. Eye protection must be worn when machine is running.
  4. Check all tooling and machine for damage before using.
  5. Sweep / vacuum up chips and leave the machine clean.
  6. No unconventional / unsafe use.
  7. You break it, you buy it!

You MUST be trained before using this machine. Please consult a member who knows what they are doing. You can help a guest with a job but guests are not permitted to use the machine themselves.

Note that knowing how to use a lathe machine is not sufficient - You must be shown by a trained member the intricacies of our machine.

Feeds and Speeds / Feed Direction

  • Learn about feeds and speeds for the cutter diameter and material you are using. Too fast or slow RPM can damage cutters and make it harder to work.
  • FS Wizard web and Android apps can calculate facing and turning speeds

Tips and Advice

Accessories

Came with lathe

  • 3-jaw chuck
  • 4-jaw chuck
  • Face plate
  • Steady rest
  • Follow rest
  • MT3 dead center for tail-stock
  • MT5 dead center for use with face plate
  • MT3 Jacob's chuck
  • Drive dog for face plate
  • Change gears for threading
  • Set of shims to adjust tool height in holder

Add-ons

  • MT3 live center
  • 1/4" size carbide insert turning 5-tool set
    • ? TCMT090204 TiN coated inserts for steel
    • ? TCMT090204 high-polish uncoated inserts for aluminum
  • 1/2" Carbide Insert Parting/Grooving Blade Accusize #2410-0012
    • 10 9 GTN-2 TiN coated inserts for steel
  • Assortment of HSS and HSS-Cobalt tool blanks for grinding custom tools

Supplies

Wishlist/TODO

Documentation

History

  • Power-fed cross slide into the far end and damaged the thrust bearing cap. Machined replacement cap from 4140 and re-straightened lead-screw.
  • E-stop button was damaged during the move to HL3.0. Replaced with similar button.