Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: change status to DOWN, needs service
(→Status: how this is PROBLEMATIC) |
(→Status: change status to DOWN, needs service) |
||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* Operational ... | * DOWN ... needs service | ||
** Bed | ** Filament Feed teeth need to be cleaned | ||
** then Zero Stop needs to be ajusted. | |||
* When this is Operational ... it can be Problematic | |||
** Bed Level and/or Zero Stop will go out of adjustment, during a print. | |||
** This causes print head to be too close to bed when starting next print. | ** This causes print head to be too close to bed when starting next print. | ||
** If head too close & extruder starts clicking, filament feed gear clogs with plastic. | ** If head too close & extruder starts clicking, filament feed gear clogs with plastic. | ||