Ultimaker 2: Difference between revisions

Ultimaker 2 (view source)

75 bytes removed , 20 April 2017

→‎Status: Update status after 2 days of work

283

edits

@@ Line 7: / Line 7: @@
 <onlyinclude>
 * Operational ... it can be Problematic
-** Bed Level and/or Zero Stop will go out of adjustment, during a print.
+** Using a Brim to hold parts to the Print Bed is strongly recommended.
-** This causes print head to be too close to bed when starting next print.
+** Bed was leveled but Print Bed is NOT perfectly flat!
-** If head too close & extruder starts clicking, filament feed gear clogs with plastic.
+** Use 1/4 or 1/8 turn Z axis Zero Stop adjusts  '''instead''' of trying to re-level the Print Bed.
-** Filament has also been jamming (near the print head) mid-print.
+** If head too close & extruder starts clicking, that can cause filament feed problems.
-* Loaded with Turquoise 3mm PLA (should use 2.85mm filament)
+* Loaded with Bright Yellow 2.85mm PLA
-** Print nozzle is '''not''' perfectly clean ... so try 110% flow
 * '''PLA ONLY!''' (to prevent nozzle contamination)
 * [[3D_Printers#Cura_15|Cura 15 Settings here]]