Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Machine Log
m (→Status) |
|||
| Line 27: | Line 27: | ||
!Notes | !Notes | ||
!Entry By | !Entry By | ||
|- | |||
|Apr 20, 2017 | |||
| | |||
* Y-axis shift of a print -- only to discover y-axis Stepper motor is '''really''' loose. Tighten screws, while making a "best guess" of what the belt tension should be. | |||
* Also tighten all of the other screws on this printer that I can see & can get to. (Many were loose.) | |||
* Lubricate X & Y axis rods using NCR Silicone Fluid. (Was a bit stiff to move head by hand. Now moving freely.) | |||
* Try moving '''only''' the relay outputs for the Head Bed to the 2nd relay on the same board. "No Joy." Will still need to find & move the control input to the 2nd relay as well. | |||
* Try a "Painters Tape Sheet" on the heat bed. Working '''very well''' with PLA/PHA. | |||
* Small tweek to leveling of the (very flat) Aluminum Heat Bed. | |||
|Allen | |||
|- | |- | ||
| Line 32: | Line 43: | ||
|Nozzle cleaned, Bowden coupler springs replaced. Prints well. Use "ABS juice" to stick ABS prints to bare bed. Prints PLA onto blue tape perfectly as well. | |Nozzle cleaned, Bowden coupler springs replaced. Prints well. Use "ABS juice" to stick ABS prints to bare bed. Prints PLA onto blue tape perfectly as well. | ||
|Igor | |Igor | ||
|- | |- | ||