Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes: add under-extruding fix
(→Known Issues and Fixes: Add a fix) |
(→Known Issues and Fixes: add under-extruding fix) |
||
| Line 16: | Line 16: | ||
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2 | * '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2 | ||
* For better results, wipe the Blue Tape Sheet with Isopropyl Alcohol a few minutes before starting to print. | * For better results, wipe the Blue Tape Sheet with Isopropyl Alcohol a few minutes before starting to print. | ||
* '''If a large solid area is under-extruding''' then try printing at 220° and 110% Flow. | |||
* To '''easily''' change the filament, rotate this printer 90° -- so that the filament spool points towards the shop door end of the shelving. | * To '''easily''' change the filament, rotate this printer 90° -- so that the filament spool points towards the shop door end of the shelving. | ||