83
edits
Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Status: Not working, needs new X homing switch
(→Known Issues and Fixes: add under-extruding fix) |
(→Status: Not working, needs new X homing switch) |
||
| Line 5: | Line 5: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* | * '''Not working, X homing switch broken!''' Igor will bring replacement part | ||
* WHITE: 2.85mm PLA (use 210°-220°) | * WHITE: 2.85mm PLA (use 210°-220°) | ||
* BLACK: 2.85mm PLA/PHA Filament (use 220°-230°) -- this is a bit more flexible than plain PLA | * BLACK: 2.85mm PLA/PHA Filament (use 220°-230°) -- this is a bit more flexible than plain PLA | ||
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||
* '''Heated bed currently not working''' | * '''Heated bed currently not working''' the relay is toast, will attempt to switch to the second relay on the board. | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||
* '''http://octopi.hacklab.to/'''</onlyinclude> | * '''http://octopi.hacklab.to/'''</onlyinclude> | ||