Changes

Jump to: navigation, search

Ultimaker 1

25 bytes added, 05:15, 7 June 2017
fixed heated bed
* OLD nozzle, so use 110% Flow
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2)
* '''Heated bed currently not working''' (mid-way through fixing that).
* [[3D_Printers#Cura_15|Cura 15 Settings here]]
* '''http://octopi.hacklab.to/'''</onlyinclude>
!Notes
!Entry By
|-
 
|Jun 7, 2017
|Switched bed heater to the second relay on the breakout board, it verks!
|Igor
|-