Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: Update based on use
m (→Status: edit for clarity) |
(→Status: Update based on use) |
||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
| Line 12: | Line 11: | ||
** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer becomes flat. | ** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer becomes flat. | ||
** If head too close & extruder starts clicking, that can cause filament feed problems. | ** If head too close & extruder starts clicking, that can cause filament feed problems. | ||
* Loaded with | * Loaded with Pastel Pink 2.85mm PLA | ||
* OLD Print Nozzle ... try 220°C @ 110% Flow. | |||
* '''PLA ONLY!''' (to prevent nozzle contamination) | * '''PLA ONLY!''' (to prevent nozzle contamination) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||