Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Machine Log
(→Status: update based on recent use) |
|||
| Line 35: | Line 35: | ||
!Entry By | !Entry By | ||
|- | |- | ||
|Jul 3, 2017 | |||
| | |||
* Replaced the filament cooling fan duct using the following printed parts: https://www.thingiverse.com/thing:17768 and https://www.thingiverse.com/thing:156119 | |||
** The fan screws were too short for this, so for now the fan is held in place by only 1 screw, until a few more longer M3 screws can be found. | |||
* At the '''very back of the print area''', the fan might still hit the rounded screw heads holding the print bed. Flat head screws have been obtained, so the 4 heatbed screws will be replaced next. | |||
|Allen | |||
|- | |||
|Jun 7, 2017 | |Jun 7, 2017 | ||