Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes: update "known good" print settings
(→Status: update w/ better "known good" settings) |
(→Known Issues and Fixes: update "known good" print settings) |
||
| Line 25: | Line 25: | ||
* This printer is in fairly rough shape mechanically. This causes the most problems with prints that have thin filled walls. | * This printer is in fairly rough shape mechanically. This causes the most problems with prints that have thin filled walls. | ||
** Printing slower and at a higher flow rate can help with getting acceptable print quality. | ** Printing slower and at a higher flow rate can help with getting acceptable print quality. | ||
*** 220°, 110% flow, 25mm/s ( | *** 220°, 110% flow, print @ 25mm/s (1/2 speed), travel @ 60mm/s (also 1/2 speed), 0.4 mm nozzle size, 2.85mm filament size are the '''safe''' settings for this. | ||
*** Excellent results have been reported using 220° | *** Excellent results have been reported using 220° & 120% flow. '''However''', anything above 110% flow makes head jams very likely. (Some filament reels will work @ higher flow, while others constantly jam.) Thus reducing the travel speed is a better answer than increasing the % flow above 110%. | ||
== Features == | == Features == | ||