Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: Update for not square/round.
(→Known Issues and Fixes: small correction) |
(→Status: Update for not square/round.) |
||
| Line 12: | Line 12: | ||
** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer becomes flat. | ** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer becomes flat. | ||
** If head too close & extruder starts clicking, that can cause filament feed problems. | ** If head too close & extruder starts clicking, that can cause filament feed problems. | ||
* Set X-axis to about 102% of Y-axis Scale to get square/round prints. (Pink 20mm X/Y/Z cube beside printer.) | |||
* Loaded with Pastel Pink 2.85mm PLA | * Loaded with Pastel Pink 2.85mm PLA | ||
* '''PLA ONLY!''' (to prevent nozzle contamination) | * '''PLA ONLY!''' (to prevent nozzle contamination) | ||