251
edits
Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
|||
| Line 5: | Line 5: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* '''DOWN''' ... Thermocouple failure ... '''DO NOT USE'''. | * Operational, after a significant head cleaning. Printing well as of 24 Sept 2017. | ||
* (????) ==> '''DOWN''' ... Thermocouple failure ... '''DO NOT USE'''. | |||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | * '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||