Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
m
→Known Issues and Fixes
(→Status: died mid-print) |
|||
| Line 20: | Line 20: | ||
==Known Issues and Fixes== | ==Known Issues and Fixes== | ||
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting | * '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting to print on Ultimaker 2 | ||
* Bed is really warped (higher up in the middle, lower down on the sides). Leveling the bed is unlikely to fix this. | * Bed is really warped (higher up in the middle, lower down on the sides). Leveling the bed is unlikely to fix this. | ||
** Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). | ** Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). | ||