Type A: Difference between revisions
Jump to navigation
Jump to search
Filament Settings up one level & add iPrint3D PETG
(→Status: update based on last use) |
(Filament Settings up one level & add iPrint3D PETG) |
||
| Line 19: | Line 19: | ||
'''IMPORTANT:''' All PETG filaments are '''not''' the same. This printer can '''only''' use PETG filaments where the maximum recommended printing temperature is '''240°C'''. (MG Chemicals, Spool3D.ca & iPrint-3D are some sources for that.) Most PETG filaments have a maximum recommended temperature of 260°C to 265°C. | '''IMPORTANT:''' All PETG filaments are '''not''' the same. This printer can '''only''' use PETG filaments where the maximum recommended printing temperature is '''240°C'''. (MG Chemicals, Spool3D.ca & iPrint-3D are some sources for that.) Most PETG filaments have a maximum recommended temperature of 260°C to 265°C. | ||
==Recommended Filament Settings== | |||
'''CURA 3 settings for iPrint3D Dark Green PETG''' | |||
'''Quality''' | |||
* Draft Quality ==> Layer Height: 0.2mm (Don't use less than this with PETG.) | |||
'''Infill''' | |||
* Infill Pattern: Zig Zag | |||
* Infill Overlap Percentage: 50 | |||
* Skin Overlap Percentage: 10 | |||
'''Material''' | |||
* Printing Temperature: 240 °C | |||
* Diameter: 1.75 mm | |||
* Flow: 100 % | |||
* Retraction Distance: 0.4 mm | |||
* Retraction Speed: 30 mm/s | |||
'''Speed''' (Testing in progress on these settings) | |||
* Print Speed: 25 mm/s | |||
* Infill Speed: 25 mm/s | |||
* Wall Speed 20 mm/s | |||
** Outer Wall Speed: 20 mm/s | |||
** Inner Wall Speed: 25 mm/s | |||
* Travel Speed 240 mm/s | |||
* Initial Layer Speed: 20 mm/s | |||
'''Travel''' | |||
* Z Hop When Retracted: SELECTED | |||
* Z Hop Height: 0.5 mm | |||
'''Cooling''' | |||
* Enable Print Cooling: UNSELECTED | |||
'''Special Modes''' | |||
* Print Sequence: One at a Time | |||