Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings
(→Known Issues and Fixes: + binder clips not) |
|||
| Line 31: | Line 31: | ||
==Recommended Filament Settings== | ==Recommended Filament Settings== | ||
'''CURA 3 settings for PLA by Filaments.ca''' | |||
'''Material''' | |||
* Printing Temperature: 190 °C | |||
* Diameter: 1.75 mm | |||
* Flow: 100 % | |||
* Retraction Distance: 0.5 mm | |||
* Retraction Speed: 40 mm/s | |||
'''Speed''' | |||
* Print Speed: 75 mm/s | |||
* Travel Speed 150 mm/s | |||
* Initial Layer Speed: 25 mm/s | |||
'''Experimental''' | |||
* Enable Costing: SELECTED | |||
'''CURA 3 settings for PETG by iPrint3D & MG Chemicals''' | '''CURA 3 settings for PETG by iPrint3D & MG Chemicals''' | ||