Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: small update for PETG
(→Machine Log: update for no axis shifts.) |
(→Recommended Filament Settings: small update for PETG) |
||
Line 59: | Line 59: | ||
'''Quality''' | '''Quality''' | ||
* Draft Quality ==> Layer Height: 0.2mm (Don't use less than this with PETG.) | * Draft Quality ==> Layer Height: 0.2mm (Don't use less than this with PETG.)<br />==> A Layer Height 0.25mm also works extremely well. | ||
'''Shell''' | '''Shell''' | ||
* Wall Thickness: 1.2 mm (3 perimeters seem to work a bit better than 2) | * Wall Thickness: 1.2 mm (3 perimeters seem to work a bit better than 2) | ||
Line 76: | Line 76: | ||
* Diameter: 1.75 mm<br />==> if possible, use the actual measured filament dia. | * Diameter: 1.75 mm<br />==> if possible, use the actual measured filament dia. | ||
* Flow: 100 % | * Flow: 100 % | ||
* Retraction Distance: 0.5 mm | * Retraction Distance: 0.5 mm<br />==> Note: I’m using the combination of “Coasting” together with a small retraction.<br /> | ||
* Retraction Speed: 25 mm/s | |||
** Retraction Retract Speed: 20 mm/s | ** Retraction Retract Speed: 20 mm/s | ||
** Retraction Prime Speed: 25 mm/s | ** Retraction Prime Speed: 25 mm/s |