Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: update loaded filament
(→Machine Log: Print Bed & Carbon Fiber Plate notes) |
(→Status: update loaded filament) |
||
| Line 8: | Line 8: | ||
'''Old/Brittle Filament''' ... do NOT leave this filament loaded when done printing! | '''Old/Brittle Filament''' ... do NOT leave this filament loaded when done printing! | ||
YS White PLA (from Amazon.ca) | |||
*'''Last known good settings''': (05-Dec-2017, Pastel Yellow PLA) '''220°''', 138% flow, print @ '''50mm/s''', travel @ '''150mm/s''', 0.4 mm nozzle size, 2.85mm filament size. | *'''Last known good settings''': (05-Dec-2017, Pastel Yellow PLA) '''220°''', 138% flow, print @ '''50mm/s''', travel @ '''150mm/s''', 0.4 mm nozzle size, 2.85mm filament size. | ||
**note: the reason the flow is pumped-up is because the print-head is misaligned and causing drag on the filament. I suspect you could even up the flow and the speed and get decent (but still crappy) prints. If you want to print slower for higher precision you may need to reduce the flow (but <110% flow at any speed will cause under-extrusion) | **note: the reason the flow is pumped-up is because the print-head is misaligned and causing drag on the filament. I suspect you could even up the flow and the speed and get decent (but still crappy) prints. If you want to print slower for higher precision you may need to reduce the flow (but <110% flow at any speed will cause under-extrusion) | ||