140 bytes added
06:16, 30 May 2018
Updated change log: replaced head parts
DOWN!!! Cannot get filament to the nozzle... Need to replace the teflon and/or PEEK piece?
'''Old/Brittle Filament''' ... do NOT leave this filament loaded when done printing!
|May 29, 2018
|Head was jammed, took it apart and replaced Hot End Isolator Coupler, Hot End Isolator Tube and PEEK Insulator with ebay parts that were in 3D printer parts bin. Seems OK now, maybe under-extruding a bit.
Retrieved from "
About Hacklab.TO Public Wiki