251
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 01:07, 9 August 2018
, 9 August 2018no edit summary
No edit summary |
|||
| Line 39: | Line 39: | ||
A copy of GpxUi can be found on the SD card in the printer. | A copy of GpxUi can be found on the SD card in the printer. | ||
==Lokbuild Print Surface== | |||
*Do not use heated bed for PLA, it will adhere to the surface no problem | |||
*Can use heated bed for ABS, use whatever temperature you normally would | |||
*for other materials see official site http://www.lokbuild.com/ or search it on internetz | |||
**according to them, it can be used with: ABS, PLA, HIPS, PET, colorFabb_XT, colorFabb nGen, colorFabb_HT, colorFabb XT-CF20 (carbon fibre), Woodfill, Bronzefill, Copperfill, Brassfill, Polymaker PC-Plus (polycarbonate), Polymaker PC-Max (polycarbonate), Polymaker PolyFlex, Ninjaflex | |||
*Lokbuild is durable. Rana has printed 100's of times on it at home and it still is good as new. | |||
----- | |||
Usage: | |||
*Use Lokbuild surface alone. Do not use tape, or "ABS Juice", or glue stick or anything | |||
*Print as you normally would. Rana finds even large prints do not curl, but use a brim or raft if you like. No fan for first layer. | |||
*To remove print, use the flat spatula to get underneath as usual. A room temperature print will just pop off easily. Lokbuild is durable, but if you really try you can scuff the surface. | |||
*You may see markings on the surface from where your print was. This is not a problem, you can print right on top of the markings as usual, they do not affect adherence of plastic to surface (at least for PLA... rana has tried other materials) | |||
*Praise Lokbuild god that you don't have to use tape anymore. | |||
*To clean: use warm-hot water with dish detergent, scrub with the green side of the sponge. Rinse with water. This should remove any markings left over from prints. The surface should look good as new. | |||
*May also clean with <10% isopropyl alcohol. | |||
*DO NOT put acetone on surface or high % isopropyl, this is will damage the surface. | |||
==Cura 3 Settings for this Printer== | ==Cura 3 Settings for this Printer== | ||