251
edits
Line 176: | Line 176: | ||
Leaning or drifting prints? Tighten all the belts, especially the Y-axis stepper motor belt. That stepper is prone to becoming loose because the Y-stepper motor puts out more power than the X. A link to a video is in the maintenance section. | Leaning or drifting prints? Tighten all the belts, especially the Y-axis stepper motor belt. That stepper is prone to becoming loose because the Y-stepper motor puts out more power than the X. A link to a video is in the maintenance section. | ||
Always store the printer with the X carriage in a corner. (It homes itself to the back left corner anyway when a print is done). But this is to prevent the X and Y axis rods from sagging over time, especially the X axis. It's a known problem, I think, I swear I read it on the internet! | |||
==Octoprint at octopi4.hacklab.to== | ==Octoprint at octopi4.hacklab.to== |