3D Printers/Creality K1: Difference between revisions

Jump to navigation Jump to search
Line 9: Line 9:
</onlyinclude>
</onlyinclude>
* Print monitoring page (must be on the hacklab wifi): http://192.168.133.60/#/home
* Print monitoring page (must be on the hacklab wifi): http://192.168.133.60/#/home
* The printer moves so fast, you may have to bump up nozzle temperature to get strong layer adhesion. I found printing PETG at 250C would look nice but with very weak layer adhesion, at 275C got strong adhesion
* If trying new filaments on it, you may have to bump up nozzle temperature to get strong layer adhesion because the printer moves so fast. Like >+15C over the recommended max temp.  
* If printing organic models and the quality is less than you want, easiest way to increase quality is to slow down print speed  
* If printing organic models and the quality is less than you want, easiest way to increase quality is to slow down print speed  
** go to the monitoring page, see the panel at middle left ("Control" with the XY home buttons), set print speed there
** go to the monitoring page, see the panel at middle left ("Control" with the XY home buttons), set print speed there

Navigation menu