251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Hardware
| Line 86: | Line 86: | ||
* screen is Big Tree Tech TFT35-E3 V3.0 | * screen is Big Tree Tech TFT35-E3 V3.0 | ||
* mainboard is Big Tree Tech SKR Mini E3 V3 | * mainboard is Big Tree Tech SKR Mini E3 V3 | ||
**Note: the TMC stepper drivers on the board usually have stealthchop enabled (for silent stepping), however stealthchop fails at speeds above 100mm/s. So for fast travel moves the firmware will switch the stepper drivers spread cycle mode. So the printer will be louder on fast travel moves. | **Note: the TMC stepper drivers on the board usually have stealthchop enabled (for silent stepping), however stealthchop fails at speeds above 100mm/s. So for fast travel moves the firmware will switch the stepper drivers to spread cycle mode. So the printer will be louder on fast travel moves. | ||
* power supply is Mean Well RSP-500-24 (the good one, not first release of this printer that had a shitty one) | * power supply is Mean Well RSP-500-24 (the good one, not first release of this printer that had a shitty one) | ||
* Printhead is Micro Swiss Direct Drive and All-Metal Hot end | * Printhead is Micro Swiss Direct Drive and All-Metal Hot end | ||
| Line 97: | Line 97: | ||
* Hiwin linear rails on X and Y axis ("good" chinese brand) | * Hiwin linear rails on X and Y axis ("good" chinese brand) | ||
* Magnetic spring steel on the print bed, with textured PEI coating | |||
== Direct control of printer == | == Direct control of printer == | ||