Changes

Jump to: navigation, search

Ultimaker 2

819 bytes added, 21:50, 1 February 2017
Add features, update status and log
[[File:Ultimaker 2.jpg|thumb|300px|Ultimaker #2, also known as "Fawkes"]]
This page documents Ultimaker #2 (Fawkes) [A phoenix from the ashes]
 
Printer lives on the third shelf of the 3D printer tower, next to the [[Type A]].
==Status==
<onlyinclude>
* Operational
* Some backlash
* Loaded with orange-red 3mm PLA
* '''Unload the orange-red PLA from the Bowden tube after use, it breaks apart and clogs the tube after several days!'''
* '''PLA ONLY!''' (to prevent nozzle contamination)
* [[3D_Printers#Cura_15|Cura 15 Settings here]]
* '''http://octopi2.hacklab.to/'''</onlyinclude>
== Features == * The Ultimaker is in working order.Original with extruder drive upgrade* Built from an incomplete kit and a bunch of parts are 3D printed* 210 x 210 x 205 mm print volume* Uses 3mm PLA filament.* Absolute max temperature: 250 C
* It is managed and accessible from the web GUI: '''http://octopi2.hacklab.to/'''
!Entry By
|-
 
|Mid-2016
|Re-printed [http://www.thingiverse.com/thing:19551 extruder drive tensioner] in ABS on Ultimaker 1, replaced Bowden tube coupler springs. Snipped 1cm off the tube ends to give couplers fresh surface to hold on to.
|Igor
|-
 
|September 26, 2015