Makerbot: Difference between revisions
Jump to navigation
Jump to search
(No difference)
|
Revision as of 23:55, 15 August 2013
Usage
The cupcake now runs off the same toolchain as the ultimakers, running the same Marlin firmware. This means you can treat it almost identially. (eg: Use Cura/tegh)
You will have to download the Cura profile from github [1] and set the dimensions in cura to match the machine. (This cannot be embedded in the profile for some reason.)
Operating ABP in tegh
The bed can be heated similar to the extruder. Note that it overshoots, raise the temperature slowly, and don't set it above 85C.
set temp b:85
Sub Pages
- Makerbot Manual -- Obsolete
- Makerbot Customization