Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
update printer status after using for hours
(→Status) |
(update printer status after using for hours) |
||
| Line 7: | Line 7: | ||
* Operational | * Operational | ||
* Loaded with Turquoise 2.85mm PLA | * Loaded with Turquoise 2.85mm PLA | ||
* | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||
* '''Heated bed will cut-out mid-print''' -- so must constantly watch Octiprint to turn heat back on. | |||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||
* '''http://octopi.hacklab.to/'''</onlyinclude> | * '''http://octopi.hacklab.to/'''</onlyinclude> | ||