Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: edit to remove line for old extruder
(→Known Issues and Fixes: remove "old nozzle" & "extruder zip-tie" note after work done.) |
(→Status: edit to remove line for old extruder) |
||
| Line 8: | Line 8: | ||
*'''Last known good settings''': (06-Jun-2017) 40 mm/s, 220 deg, 110% flow, nozzle size 0.3mm | *'''Last known good settings''': (06-Jun-2017) 40 mm/s, 220 deg, 110% flow, nozzle size 0.3mm | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ||