Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: Heatsink & Clean/Lube shafts
(→Status: edit to remove line for old extruder) |
(→Machine Log: Heatsink & Clean/Lube shafts) |
||
| Line 37: | Line 37: | ||
!Entry By | !Entry By | ||
|- | |- | ||
|June 23, 2017 | |||
| | |||
* Use Thermal Adhesive to put a re-purposed VGA Heatsink onto the end of the Extruder Stepper motor. (NO adhesive in the center, near the shaft end.) | |||
* Head NOT moving smothly '''again'''! Use Silicone Fluid to lube/clean all X/Y shafts. | |||
** Double-check that no end-cap screw is toooo thigh while doing this. | |||
|Allen | |||
|- | |||
|Jun 8-9, 2017 | |Jun 8-9, 2017 | ||