Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
→Status: new fan duct is a PROBLEM
(→Status: update for White PLA on this printer) |
(→Status: new fan duct is a PROBLEM) |
||
| Line 5: | Line 5: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* Operational | * Operational ... but '''difficult to use'''. | ||
* Replacement Filament Fan Duct extremely close to print bed ... so catches/traps any loose filament when print starts. | |||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | * '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* White 2.85mm PLA ... will jam if leave head hot too long without printing. | * White 2.85mm PLA ... will jam if leave head hot too long without printing. | ||