Ultimaker 1: Difference between revisions

Jump to navigation Jump to search
99 bytes removed ,  11 October 2017
→‎Known Issues and Fixes: update a note for PLA only.
(→‎Machine Log: normal service)
(→‎Known Issues and Fixes: update a note for PLA only.)
Line 15: Line 15:
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting your print on Ultimaker 2
* For better results, wipe the Blue Tape Sheet with Isopropyl Alcohol a few minutes before starting to print.
* For better results, wipe the Blue Tape Sheet with Isopropyl Alcohol a few minutes before starting to print.
* '''If a large solid area is under-extruding''' then try printing at 220° and 110% Flow. For the PLA/PHA also use 100% fill. (Or figure out the correct retraction settings for that filament.)
* '''If a large solid area is under-extruding''' then try printing PLA at 220° and 110% Flow.
* To '''easily''' change the filament, rotate this printer 90° -- so that the filament spool points towards the shop door end of the shelving.
* To '''easily''' change the filament, rotate this printer 90° -- so that the filament spool points towards the shop door end of the shelving.


283

edits

Navigation menu