3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 18:08, 28 January 2020
, 28 January 2020→Status
(→Status) |
(→Status) |
||
| Line 21: | Line 21: | ||
| Blue PETG | | Blue PETG | ||
| Default Slic3r bundle settings | | Default Slic3r bundle settings | ||
| | | Default Slic3r bundle settings | ||
| Last known good workflow (for Chalmers) | | :: Last known good workflow (for Chalmers) :: | ||
1. Install slicer config | |||
2. Install slicer config bundle | |||
3. set slicer to simple mode | |||
4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | |||
5. slice model | |||
6. load sliced model into GpxUi | |||
7. translate to Replicator 2 RepRap | |||
|- | |- | ||
| Nov, 2018 | | Nov, 2018 | ||